Fujitsu AJ 126LELDH Series - Page 893

¢ Indoor unit function setting
NOTE:
Perform this setting on the master remote controller.
1. While displaying the function setting screen, press the TEMP. “ ” or TEMP. “ ” button to se-
lect the 2-wire remote controller address.
Function setting screen
Example: Selecting the 2-wire remote
controller address (002-03)
2. Press the START/STOP
/
button to switch to the function number setting.
Example: Selecting the 2-wire remote
controller address
Function number
3. Press the TEMP. “ ” or TEMP. “ ” button to adjust the function number.
Function number
4. Press the START/STOP
/
button to switch to the setting number adjustment.
Function number
Setting number
5.
Press the TEMP. “
” or TEMP. “ ” button to adjust the setting number.
Setting number
6. Press the START/STOP
/
button. The data will be transferred to the indoor unit, and the set-
ting result will be displayed.
2-6. Indoor unit (setting by UTY-RSR
, UTY-RHR)
- (07-97) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS