7. To return to the 2-wire remote controller address selection screen, press the START/STOP
button. If setting has been completed, press FAN “ ” button to return to the Menu 2-F1 item
selection screen.
When returning to the 2-wire remote
controller address selection screen
Setting completed and returning to
the Menu 2-F1 item selection screen
RELATED LINKS
"Completion of setting mode" on page 07-37
"Function details" on page 07-108
¢ Setting up each indoor unit
Setting must be performed on each indoor unit by repeating following procedures.
• "Preparation" on page 07-96
• "Indoor unit function setting" on page 07-97
• "Completion of setting mode" on page 07-37
0001 0101 0201 1301 1401 15010 1 2 0 1 0
Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit
Simple remote
controller
Simple remote
controller
Simple remote
controller
¢
Resetting the power after setting up all indoor units
NOTES:
• If the reset is not performed, function cannot be read correctly.
• After all the functions have been set, the circuit breaker needs to be switched off for at least 2
minutes.
– After the 2 minutes has passed, power can be restored.
– The set function is stored in the PCB and will remain in memory even when the power of in-
door unit is turned off.
However setting function is effective after disconnecting the power supply and then recon-
necting it.
• Record the latest configuration of the indoor unit function setting on a label, and put the label on
the unit so it can be used for after-sales service operations.
2-6. Indoor unit (setting by UTY-RSR
, UTY-RHR)
- (07-98) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
