4. Press the START/STOP
button to switch to the indoor unit address setting.
Function number
Indoor unit address
5.
Press the TEMP. “
” or TEMP. “ ” button to adjust the indoor unit address number.
Indoor unit address Example: Selecting indoor unit
address data “12”
6. Confirm the selected indoor unit address data by pressing the START/STOP
button. The
data will be transferred to the indoor unit.
GOODERROR
Indoor unit address
Example: When indoor unit address data "12" is set up
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, “- -” is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
7. To return to the 2-wire remote controller address selection screen, press the START/STOP
button. If setting has been completed, press FAN “ ” button to return to the Menu 2-F1 item
selection screen.
When returning to the 2-wire remote
controller address selection screen
Setting completed and returning to
the Menu 2-F1 item selection screen
1-4. Address setting by remote controller
- (07-35) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
