Button name and function
Address code or function indicator on the remote controller is as shown in the figures below.
• For an outline of the address setting, refer to "Address setting" on page 07-4.
• For the details of function number and setting number used for the function setting, refer to "Func-
tion details" on page 07-108.
• It does not matter whether the refrigerant circuit address or indoor unit address is set first. (The
method shown here sets the indoor unit address first.)
• During address setting mode, indoor unit reject the any operation command from remote con-
troller.
Indoor unit address valid range: 00 to 63
Refrigerant circuit address valid range: 00 to 99
Function number
Remote controller address
FAN button
Each time this button is pressed,
the fan setting changes among
“Remote controller address,”
“Function number” and “Setting number.”
Setting number
START/STOP button
Transmits address setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers
UTY-RSK* (With operation mode)
UTY-RHK* (Without operation mode)
01: Indoor unit address
02: Refrigerant circuit address
Remote controller address
setting number 00 to 15
Indoor unit address valid range: 00 to 63
Refrigerant circuit address valid range: 00 to 99
Function number
Remote controller address
FAN button
Each time this button is pressed,
the fan setting changes among
“Remote controller address,”
“Function number” and “Setting number.”
Setting number
START/STOP button
Transmits address/function setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers
01: Indoor unit address
02: Refrigerant circuit address
Remote controller address
setting number 00 to 15
RELATED LINKS
"Indoor unit (setting by UTY-RSK, UTY-RHK)" on page 07-99
Entering setting mode
Hold down the 3 buttons of SET TEMP. “ ”, SET TEMP. “ ”, and FAN at the same time for 5 sec-
onds or longer. The setting mode will be activated.
Initial display of setting mode
1-4. Address setting by remote controller
- (07-40) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
