Indoor unit address setting
1. In initial display of the setting mode, by pressing SET TEMP. “ ” button or SET TEMP. “ ”
button, select a remote controller address. (Select the indoor unit you want to operate.)
Initial display of
address setting mode
Example: When remote controller address
“01” is selected
Remote controller address
2. Press the FAN button. “Function number” indicator flashes.
3. Display the function number “01” by pressing SET TEMP. “ ” button or SET TEMP. “ ” but-
ton.
4. Press the FAN button. “Setting number” indicator flashes.
5.
Set up the indoor unit address data by pressing SET TEMP. “ ” button or SET TEMP. “ ”
button. (Setting range is from “00” to “63”.)
Example: When indoor unit address data “12” is set
Indoor unit address data
1-4. Address setting by remote controller
- (07-41) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
