6. Confirm the selected indoor unit address data by pressing the START/STOP
button. The
data will be transferred to the indoor unit.
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, “- -” is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
Refrigerant circuit address setting
NOTE: Perform this setting on the master remote controller.
1. In initial display of the address setting mode, by pressing SET TEMP. “ ” button or SET
TEMP. “
” button, select a remote controller address. (Select the indoor unit you want to oper-
ate.)
If the indoor unit you want to operate has already been selected, skip this step.
Initial display of
address setting mode
Example: When remote controller address
“01” is selected
Remote controller address
2. Press the FAN button. “Function number” indicator flashes.
3.
Display the function number “02” by pressing SET TEMP. “ ” button or SET TEMP. “ ” but-
ton.
1-4. Address setting by remote controller
- (07-42) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
