Fujitsu AJ 126LELDH Series - Page 842

 Entering setting mode
When “Function Setting” on the Maintenance screen is touched, Installer Password Verification
screen is displayed.
Enter the Installer Password, and touch “OK”. Function Setting screen is displayed.
Previous
Page
Back
Next
Page
Page 2/ 3 Maintenance
Test Run
R.C. Address
Setting
Function Setting
I.U. Address
Setting
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
Function setting mode initial display
 Indoor unit address setting
1. Touch “Address” on the Function Setting screen.
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
2. Address screen is displayed. Select the address of the indoor unit whose function number is to
be set by touching “
” or “ ”.
002–01
Address
Cancel OK
All
When “OK” is touched, the display returns to the Function Setting screen.
3. Touch “Function No.” on the Function Setting screen.
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
4.
Function No. screen is displayed. Set the Function No. “01” by touching “ ” or “ ”.
01
Function No.
Cancel OK
When “OK” is touched, the display returns to the Function Setting screen.
1-4. Address setting by remote controller
- (07-46) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS