5. Touch “Setting” on the Function Setting screen.
[002–01]
[01]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
6. Setting screen of “Setting No.” is displayed. Set the Setting No. by touching “ ” or “ ”. (Set-
ting range is from “00” to “63”.)
12
[002–01]
[01]
Function Setting
Cancel OK
Address
Function No.
Setting No.
Example: When indoor unit address data "12" is set
When “OK” is touched, the Function Setting verification screen is displayed.
7. Touch “Yes” on the verification screen.
No Yes
Function Settung
Function setting will be performed. OK?
After the Setting screen is displayed, the display returns to the Function Setting screen.
Refrigerant circuit address setting
1. Touch “Address” on the Function Setting screen.
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
2. Address screen is displayed. Select the address of the indoor unit whose function number is to
be set by touching “
” or “ ”. When setting at all the indoor units, touch “All”.
002–01
Address
Cancel OK
All
When “OK” is touched, the display returns to the Function Setting screen.
1-4. Address setting by remote controller
- (07-47) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
