Fujitsu AJ 126LELDH Series - Page 844

3. Touch “Function No.” on the Function Setting screen.
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
4. Function No. screen is displayed. Set the Function No. “02” by touching “ ” or “ ”.
02
Function No.
Cancel OK
When “OK” is touched, the display returns to the Function Setting screen.
5. Touch “Setting” on the Function Setting screen.
[002–01]
[02]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
6. Setting screen of “Setting No.” is displayed. Set the Setting No. by touching “ ” or “ ”. (Set-
ting range is from “00” to “99”.)
Example: When refrigerant circuit address data "18" is set
18
[002–01]
[02]
Function Setting
Cancel OK
Address
Function No.
Setting No.
When “OK” is touched, the Function Setting verification screen is displayed.
7. Touch “Yes” on the verification screen.
No Yes
Function Settung
Function setting will be performed. OK?
After the Setting screen was displayed, the display returns to the Function Setting screen.
 Completion of setting mode
To exit the setting mode and return to the Maintenance screen, touch “Back” on the Function Setting
screen.
1-4. Address setting by remote controller
- (07-48) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS