Fujitsu AJ 126LELDH Series - Page 865

4. With referring to "Setting list" on page 07-70, press the SELECT button (SW108) to display the
code number of the mode you want to set on the LED105.
LED105 LED104
LED105 LED104
Example: To select switching between Forced stop and Emergency stop
Then, press the ENTER button (SW109) to confirm the mode you want to set.
Flashing of LED105 stops and lights a number, and the lit number on the LED104 starts to
flash.
LED105 LED104 LED105 LED104
5. Again, with referring to "Setting list" on page 07-70, press the SELECT button (SW108), and
display the code number of the function you want to set on the LED104.
Example: To select the Emergency stop function
LED105 LED104 LED105 LED104
Then, press the ENTER button (SW109) to confirm the function you want to set.
Flashing of LED104 stops and lights a number.
LED105 LED104
LED105 LED104
To set another function, press the ENTER button (SW109) in the completed state of current
setting. Then, repeat steps 4. and 5. to set each function.
LED105 LED104
LED105 LED104
6. After all necessary function settings are completed, press the ENTER button (SW109) in the
setting completed state shown in the previous step.
5 seconds after, even if the ENTER button (SW109) is not pressed, the LED105 starts to flash
automatically.
LED105 LED104
LED105 LED104
Then, press the MODE/EXIT button (SW107) to exit the function setting mode.
LED105 LED104
LED105 LED104
2-1. Setting on outdoor unit PCB
- (07-69) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS