3. Press the FAN button to proceed to number setting. To return to the function number adjust-
ment, press the FAN button again.
4.
Press the SET TEMP. or button to adjust the setting number.
Each time the MODE button is pressed, it switches between the left digit and the right digit.
5. Send the information by pressing the START/STOP button once. A beeping sound (2 short
beeps, 1 long beep, 2 short beeps, and 1 long beep) will be emitted if the command is accept-
ed.
Beeps are emitted
intermittently
(2 short beeps,
1 long beep, 2 short beeps,
and 1 long beep)
In the following case, the setting signal will not be accepted correctly and 5 short beeps will be
emitted:
• The function setting number is set out of range
2-4. Indoor unit (setting by wireless remote controller)
- (07-88) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
