6. SETTINGS ON WEB INTERFACE
6-23
5. Click the [Next] button.
6. Referring to the following table, set up the PPPoE connection settings and choose
a service name.
*
1
: Memorize the Username and Password set here, as they are required to con-
nect to the internet via PPPoE.
*
2
: FELCOM501 only.
*
3
: The message “Invalid value(s)” appears under the following circumstance, af-
ter the [Next] button is clicked.
• Invalid characters using in the user name or password.
• Number of characters used for the user name or password is more than the
maximum, or less than the minimum.
• The combination of characters does not meet the requirement.
• Password and confirmation do not match.
Item Description
Connection Type Shows "PPPoE".
Group Name Shows the registered group name.
Connection List
PPPoE Username
Input the user name*
1
for PPPoE. Use ASCII characters other
than space, ”, . Maximum of 15 characters.
PPPoE Password*
3
Input the password*
1
for PPPoE. Use ASCII characters other
than space, ”, . The password must contain upper and lower-
case alphanumeric characters with a minumim of 8 characters
and a maximum of 15 characters.
Password(Confir-
mation)*
3
Re-Input the password entered at PPoE Password.
Data connection
service
Select the service from "Standard Data", "Streaming 8kbps",
"Streaming 16kbps", "Streaming 32kbps", "Streaming 64kbps",
"Streaming 128kbps", "Streaming 256kbps"*
2
.
Header Compres-
sion
Put a [9] in the box to activate the header compression.
Compress the header area of the communication protocol, and
reduce the communication volume.
Prev button Return to the previous step while keeping the setting information.
Next button Go to the next step.
To Next Page
Loading...
