6. SETTINGS ON WEB INTERFACE
6-32
8. Referring to the table below, set up the WAN connection settings.
9. Click the [Finish] button.
The message "Restart the system to apply the changes." appears.
10. Click the [OK] button.
The message "Restart the system to apply the changes." appears.
11. Click the [Close] button to close the message.
The equipment restarts to apply the settings.
Item Description
Connection Type Shows the registered connection type.
Group Name Shows the registered group name.
APN Put a [9] in the box to use Access Point Name in the SIM card.
Use ASC II characters (other than “, ’) for the names of connec-
tion destinations (maximum 100 characters).
APN Username Input the user name specified by provider (maximum 50 char-
acters). Ok to leave blank.
APN Password Input the password specified by provider (maximum 50 charac-
ters). Ok to leave blank.
Auto connection at
startup
Put a [9] in the box to enable the data connection service se-
lected at step 6 when power is turned on.
Persistent Put a [9] in the box to activate automatic reconnection when a
request from the network is received.
Note: This function will not be activated when the data connec-
tion is disconnected manually, for example, the power is turned
off,
Prev button Return to the previous step while keeping the setting informa-
tion.
Finish button Register the setting information, then go to the [Group] menu.
To Next Page
Loading...
