6. SETTINGS ON WEB INTERFACE
6-40
5. Click [Add filter] button.
The following pop-up window appears.
6. Referring to the following table, set up the IP filter according to your application
and system.
7. Click the [Add] button.
The message "Applied." appears and the settings appear in the [IP Filter List].
8. Click the [Close] button to close the message.
Item Description
Action Select the IP filter action from "Pass", "Drop", or "Reject".
Select "Pass" to set "TCP/UDP(NAPT)" at [Protocol].
Filter Direction Select the IP filter direction from "WANoLAN" or "LANoWAN".
Select [WANoLAN] to set [TCP/UDP(NAPT)] at [Protocol].
Destination
Address
Input, or change the destination address (IPv4 address).
Source Ad-
dress
Input, or change the source address (IPv4 address).
Protocol Select the IP filter protocol from "All", "ICMP", "Any", "TCP/UDP", or
"TCP/UDP(NAPT)".
• If [Protocol] is [Any] only, input the protocol number (1-255).
• If [Protocol] is [TCP/UDP] only, select "TCP", "UDP", or "TCP/UDP"
from the pull-down menu. then input the port number (range: 1-
65535).
• If [Protocol] is [TCP/UDP(NAPT)] only, select "TCP" or "UDP", then
input the port numbers for "Dest." and "From" (range: 1-65535).
Add button Register the setting information, then close the pop-up window.
Cancel button Cancel the setting information, then close the pop-up window.
Filter settings appear in the IP Filter List.
To Next Page
Loading...
