1. BASIC OPERATION
1-5
5. Turn on the power switch on the Communication Unit.
IP Handsets connected to the Communication Unit can take up to 40 seconds to
power up and show the start-up screen.
Wait approximately three minutes for the main screen to display.
When the main screen Shows the icons and in green on the status bar,
communication is possible.
Main screen
Note 1: Usually, a few minutes is required for the above screen to display. If there
are obstacles or interference in the path of the satellite, more time may be re-
quired.
Note 2: You may be asked for PIN code depending on SIM card settings. If pass-
word is required, go to step 6.
Note 3: You can call the 505 emergency or 32/38/39 urgency number with no PIN
code. Press the key to select [Rescue]. See section 2.4 how to use the res-
cue call.
6. Press the 0 to 9 key to input the 4- to 8-digit PIN code.
7. Press S or T to select [OK], then press the Enter key.
If the PIN code is input correctly, the main screen appears on the IP Handset. If
input wrong, the message "Invalid PIN" appears.
To Next Page
Loading...
