Furuno FELCOM501 - Page 68

3. SETTINGS FOR IP HANDSET
3-18
2. With [Ext Call Limit] selected, press the Enter key.
3. Press W or X to select [Enabled] or [Disabled], then press the Enter key.
• Enabled: Permits external calls.
• Disabled: Prohibits external calls.
The message "Wait response..." appears, followed by "Request completed.
Check the status." when the process is complete.
4. Press the key to go back to the main screen.
How to set the request of the caller code
If the caller code has been requested, the user is always prompted for a 5 digit caller
code when making the outside calling. See section 6.3 how to set the caller code.
Note: [Destination] must be [Free] to use this function.
1. In the [Admin Settings] menu, press S or T to select the [Restrictions] menu, then
press the Enter key.
2. Press S or T to select the [Caller Code] menu, then press the Enter key.
3. Press W or X to select [No Request] or [Request], then press the Enter key.
The message "Wait response..." appears, followed by "Request completed.
Check the status." when the process is complete.
4. Press the key to go back to the main screen.