3. SETTINGS FOR IP HANDSET
3-19
How to set the outside call filter
If the filter has been activated, the user is restricted to call the destination only set in
the Web interface. See section 6.2 how to set the outside call filter.
Note: [Caller Code] must be [No Request] to use this function.
1. In the [Admin Settings] menu, press S or T to select the [Restrictions] menu, then
press the Enter key.
2. Press S or T to select the [Destination] menu, then press the Enter key.
3. Press W or X to select [Free] or [Restrict], then press the Enter key.
• [Free]: Deactivates the outside call filter.
• [Restrict]: Activates the outside call filter.
The message "Wait response..." appears, followed by "Request completed.
Check the status." when the process is complete.
4. Press the key to go back to the main screen.
To Next Page
Loading...
