Furuno NAVNET TZ2 TZTL12F - Page 370

15. OTHER FUNCTIONS
15-9
[CALIBRATION] section
[DATA DAMPING] section
[FUSION] section
[BROWSER INSTALLATION] section
Others menu items
Menu item Description Options (setting range)
[Heading] Offset heading data. -180.0° to +180.0°
[Speed Through
Water]
Calibrate speed data. Enter amount in percentage. -50° to +50°
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50° to +50°
[Wind Angle] Offset wind angle data. -180.0° to +180.0°
[Sea Surface
Temperature]
Offset sea surface temperature data. -10° to +10°
Menu item Description Options (setting range)
[COG & SOG] Set data damping time. The lower the set-
ting the faster the response to change.
0 to 59 seconds
[Heading]
[Speed Through Water]
[Wind Speed&Angle]
[Rate of Turn]
Menu item Description Options (setting range)
[Connect to Fu-
sion]
Connect to your Fusion equipment.
[Fusion Auto
Volume]
Set to [ON] to allow this unit to control the Fusion volume.
[Minimum
Speed]
Set the minimum speed threshold. Exceeding this
speed activates volume auto control.
0.0 kn to 19.9 kn
[Maximum
Speed]
Set the maximum speed threshold. 0.1 kn to 99.0 kn
[Volume In-
crease]
Set the amount of extra volume to output. 10% to +50%
Menu item Description Option (setting range)
[FAX-30 Browser] Show the Facsimile Receiver FAX-30 display.
[FA-30 Browser] Show the AIS Receiver FA-30 display.
[FA-50 Browser] Show the AIS Receiver FA-50 display.
Menu item Description Option (setting range)
[Chart Master Device] Set to ON to set this equipment as the chart master and share one System
ID and chart unlock code in the network.
Note 1: For monitors connected to the TZT2BB via the HDMI OUT2 port,
the menu items [Connect to the Internet] and [Wireless LAN Settings] do not
appear in the [General] menu.
Note 2: If you change the setting for [Master Chart Device] to [OFF], the
message "Charts have to be unlocked again if you change the Chart Master
device. Are you sure you want to proceed?" appears. Tap [OK] to change
the device, or tap [CANCEL] to cancel.
[System ID] The system ID for this device within the network.
[IP Address] IP address for this unit within the network.