GE Security Vigilant VS2 User Manual

Chapter 3: System operation
154 Vigilant VS1 and VS2 Technical Reference Manual
Conducting a lamp test
A lamp test lights all of the LEDs on the panel and the LED annunciator and tests the
LCD so that you can verify proper operation. LEDs stay on for 15 seconds.
To conduct a lamp test:
1. Display the Test. menu
2. Choose Lamp Test.
3. Press Enter.
4. Verify that all LEDs on the panel, the LCD, and the
LED annunciator (if used) work properly.
Main Menu
Reports
Test
Control
Program
⇩
Test
Test Fire
Dialer
Lamp Test
Activating and restoring output devices
Activating an output device on a signaling line circuit (SLC) turns on its output. This is
typically done to test individual strobes, horns, and other notification appliances.
Restoring the device turns it off again.
Notes
• Input devices cannot be activated. If you attempt to activate an input device, the
message “Invalid device” is displayed.
• Disabled devices must be manually enabled and then restored. See “Disabling
and enabling devices” on page 156.
• Latched outputs must be manually unlatched and then restored. See “Unlatching
latched output device” on page 155.

GE Security Vigilant VS2 Specifications

General

Brand	GE Security
Model	Vigilant VS2
Category	Control Panel
Language	English