Chapter 4: Reports
Vigilant VS1 and VS2 Technical Reference Manual 177
To view a Comm Retries diagnostic report:
1. Press the menu button and choose Reports.
2. Choose Diagnostics.
3. Choose Comm Retries.
Main Menu
Reports
Test
Control
Program
⇩
Reports
Internal Status
Device Details
Diagnostics
⇩
Diagnostics
Comm Retries
Response Quality
To view a Response Quality diagnostic report:
1. Press the menu button and choose Reports.
2. Choose Diagnostics.
3. Choose Response Quality.
4. Enter the quality percentage (0 to 100).
This is a communication percentage value that is
used to displa
the device’s minimum recorded pulse
strength percentage. Enter “80” to list devices that
are communicating up to 80 percent of their
maximum pulse strength. Enter “50” to list devices
that are communicating up to 50 percent of their
maximum pulse strength (devices communicating
better than 50% are not included in the report).
Main Menu
Reports
Test
Control
Program
⇩
Reports
Internal Status
Device Details
Diagnostics
⇩
Diagnostics
Comm Retries
Response Quality
⇩
Response Quality
Quality % 000
Internal Fault report
The Internal Fault report displays information about an internal fault event (event ID
48) that has occurred on the system. The report contains information for that is
important for technical support when troubleshooting the internal fault event and
should typically only be run when you are asked to do so by a technical support
representative.
To Next Page
Loading...
