GE Security Vigilant VS2 User Manual

Chapter 5: Diagnostics, maintenance, and testing
190 Vigilant VS1 and VS2 Technical Reference Manual
Replacing a device in alarm
You can replace a device with a new device of the same type while it is in alarm. You
may need to do this because the device is faulty or for other troubleshooting reasons.
If you replace a device while it is in alarm, the device and control panel operate as
follows:
• When the device in alarm is removed, the control panel remains in alarm and a
trouble event is displayed.
• The new device does not go into alarm when it is installed, but the LCD displays a
second trouble event when the new device is detected by the panel.
• When the control panel resolves the new device, the alarm condition restores and
the two trouble events clear on the control panel.
Note: If the device causing the alarm is reinstalled, the device goes back into alarm
and the alarm condition does not restore.

GE Security Vigilant VS2 Specifications

General

Brand	GE Security
Model	Vigilant VS2
Category	Control Panel
Language	English