GE Security Vigilant VS2 User Manual

Chapter 2: Front panel programming
Vigilant VS1 and VS2 Technical Reference Manual 55
Restarting the panel
The Panel Restart command restarts (reboots) the panel without having to cycle AC
power.
To restart the panel:
1. Press the menu button and choose Program.
2. Choose Panel Restart.
3. Enter your level two password (or greater).
4. Choose Yes to restart the panel.
— or —
Choose No to cancel.
Main Menu
Reports
Test
Control
Program
⇩
Program
Laptop Enable
Programmable Keys
Panel Restart
⇩
Enter Password
0000
⇩
Panel Restart
Yes
No
Enabling RS232 communication
The RS232 CU Enable command lets you connect a PC to the control panel by means
of the optional RS232 card. This enables you to use the Configuration Utility (CU) to
program the panel and upload or download panel data.
Note: The RS232 CU Enable command times out (turns off) after four minutes of
inactivity, meaning that if the command is enabled but does not connect to the CU PC
within four minutes, the command turns off and must be reenabled.
To enable RS232communication:
1. If you are using a printer, disconnect the printer cable
from the RS-232 card.
2. Connect the configuration utility computer to the RS-
232 card.
3. Press the menu button and choose Program.
4. Choose RS232 CU Enable.
The RS232 CU Enable screen is displayed.
Main Menu
Reports
Test
Control
Program
⇩
Program
Restore Defaults
Unattended Dnld
RS232 CU Enable
⇩

GE Security Vigilant VS2 Specifications

General

Brand	GE Security
Model	Vigilant VS2
Category	Control Panel
Language	English