GE Security Vigilant VS2 User Manual

Chapter 2: Front panel programming
66 Vigilant VS1 and VS2 Technical Reference Manual
Incremental programming continues based on the
settings you made above.
7. If you chose to label devices and/or zones, use the
procedures that follow to enter labels.
8. When incremental programming is complete, the
system returns you to the banner screen.
Auto Program
System Busy
################
<Back <Cancel
⇩
Devices Old/New
Loop 1 XXX/YYY
Loop 2 XXX/YYY
<Continue
— or —
Devices: Old/New
XXX/YYY
<Continue
Labeling devices
If you set the Label Devices incremental programming option to yes, follow this
procedure to label the devices.
To label devices:
1. Next to “Device,” enter the number of the device to
be labeled.
2. Enter a text label for the device (two lines of 20
characters). The default label is “Loop X Device XXX.”
3. Press Enter to save the label and go to the next
number of the device.
Note: Pressing the Enter button saves the current
label and displays the next device number. This lets
you move quickly from one device to the next.
4. Repeat steps 2 and 3 until all devices are labeled.
5. When you have finished labeling, place the cursor on
the device number, and press the Cancel button to
continue with the next incremental programming
option.
Loop 1 Device 001
Label goes here
Label continued
<Save <Back
See “Programming relay and sounder detector bases” on page 95.

GE Security Vigilant VS2 Specifications

General

Brand	GE Security
Model	Vigilant VS2
Category	Control Panel
Language	English