page | 119
Basic Operation
Menu System
4. Press the ▲ or ▼ buttons to select UDP Settings.
5. Press the OK button to enter the menu.
6. The current UDP access status will be displayed.
7. Press the OK button, again, to edit the current setting.
8. Press the ▲ or ▼ buttons to select either Enabled or Disabled. This setting is used
to allow or prevent UDP access. In this example, we will leave the IP mode setting as
Enabled.
9. Press the OK button to save the current changes. For this example, we will leave the
setting as Enabled.
UDP access:
enabled
UDP access: (edit)
enabled
UDP access:
enabled
LAN
POE
5V DC
1 2
Matrix Controller
Status
IR
Power
Menu
1 2 3
4 5 6
7 8 9
In 0 Out Set
Clear
Mask
Preset
Back
OK
Lock
udp settings
OR
To Next Page
Loading...
