Gefen EXT-CU-LAN - Set_Gateway

page | 197
Advanced Operation
Commands
#set_gateway
Sets the gateway address for the desired port on the Matrix Controller. The gateway
address must be typed using dot-decimal notation. The Matrix Controller must be rebooted
after executing this command. The default gateway is 192.168.1.254.
Syntax
#set_gateway port addr
Parameters
port
Type: INTEGER
Accepts a number from the table below, specifying the desired port.
port Description
1
Control Port (LAN 1)
2
Video Port (LAN 2)
addr
Type: ADDRESS
The gateway address of the Matrix Controller. This address must be specied
in dot-decimal notation.
Example
#set_gateway 2 192.168.1.1
GATEWAY 2 192.168.1.1
Related Commands
#get_gateway
#get_ip_address
#get_ip_mode
#get_ipcong
#get_netmask
#get_web_port
#set_ip_address
#set_ip_mode
#set_netmask
#set_port_mode
#set_web_port