Gefen EXT-CU-LAN - Set_Udp_Access

page | 206
Advanced Operation
Commands
#set_udp_access
Enables or disables UDP access. The default setting is enabled.
Syntax
#set_udp_access state
Parameters
state
Type: INTEGER
Accepts a number from the table below, specifying the desired state.
state Description
0
Disabled
1
Enabled
Example
#set_udp_access 1
UDP_ACCESS 1
Related Commands
#get_udp_access
#get_udp_echo_access
#get_udp_echo_ip
#get_udp_echo_port
#get_udp_port
#set_udp_echo_access
#set_udp_echo_ip
#set_udp_echo_port
#set_udp_port
Advanced Operation