page | 93
Selecting Presets
Before using the front panel to select presets, use the built-in Web interface to add and
congure presets. See Using Presets (page 63) for more information. To access routing
presets, use the following procedure.
1. From the standby screen, press the Preset button. See Accessing the Menu System
(page 75) for information on how to display the standby screen.
2. The Enter Preset ID screen will be displayed:
3. Select the desired preset. There are two methods:
► Select by Preset ID
a. Use the numeric keypad to enter the Preset ID. If you make a mistake,
press the Clear button to erase the entry. Press the OK button to accept
the selection.
Basic Operation
Menu System
enter preset id
browse
OR
LAN
POE
5V DC
1 2
Matrix Controller
Status
IR
Power
Menu
1 2 3
4 5 6
7 8 9
In 0 Out Set
Clear
Mask
Preset
Back
OK
Lock
To Next Page
Loading...
Need help?
General