Gefen EXT-CU-LAN - Set_Ip_Address

page | 198
Advanced Operation
Commands
#set_ip_address
Sets the IP address for the desired port on the Matrix Controller. The IP address must be
entered using dot-decimal notation. The Matrix Controller must be rebooted after executing
this command. The default IP address for the control port (LAN 1) is 192.168.1.74.
The default IP address for the video port (LAN 2) is 192.168.1.75.
Syntax
#set_ip_address port addr
Parameters
port
Type: INTEGER
Accepts a number from the table below, specifying the desired port.
port Description
1
Control Port (LAN 1)
2
Video Port (LAN 2)
addr
Type: ADDRESS
The IP address of the Matrix Controller. This address must be specied
in dot-decimal notation.
Example
#set_ip_address 2 192.168.1.75
IP_ADDRESS 192.168.1.75
Related Commands
#get_gateway
#get_ip_address
#get_ip_mode
#get_ipcong
#get_netmask
#get_web_port
#set_gateway
#set_ip_mode
#set_netmask
#set_port_mode
#set_web_port