Gefen EXT-CU-LAN - Commands

page | 170
Commands
Command Description
#factory_reset
Resets the Matrix Controller to factory-default settings
#get_block
Returns the “block” status of the specied input
#get_discovery
Returns the Discovery Service status
#get_discovery_mode
Returns the mode of the Discovery Service
#get_rmware_version
Returns the current version of rmware
#get_gateway
Returns the gateway address
#get_ip_address
Returns the IP address
#get_ip_mode
Returns the IP mode
#get_ipcong
Returns the current IP settings
#get_mask
Returns the mask status of the specied output
#get_netmask
Returns the subnet mask
#get_telnet_access
Returns the Telnet access status
#get_telnet_pass
Returns the Telnet password status
#get_telnet_port
Returns the Telnet listening port
#get_udp_access
Returns the UDP access status
#get_udp_echo_access
Returns the UDP server echo status
#get_udp_echo_ip
Returns the address of the UDP echo server
#get_udp_echo_port
Returns the listening port of the UDP echo server
#get_udp_port
Returns the UDP listening port
#get_web_port
Returns the HTTP listening port
#help
Returns the list of available commands
#reboot
Reboots the Matrix Controller
#set_block
Blocks the A/V signal on the specied input
#set_discovery
Enables or disables the Discovery Service
#set_discovery_mode
Sets the Discovery Service mode
#set_gateway
Sets the gateway address
#set_ip_address
Sets the IP address of the Matrix Controller
#set_ip_mode
Sets the IP mode
#set_mask
Blocks the A/V signal on the specied output
#set_netmask
Sets the net mask
#set_port_mode
Sets the network port mode
#set_showme
Enables or disables the “Show Me” feature
#set_telnet_access
Enables or disables Telnet access
#set_telnet_port
Sets the Telnet listening port
#set_udp_access
Enables or disables UDP access
Advanced Operation Advanced Operation