Gefen EXT-CU-LAN - Set_Web_Port

page | 211
Advanced Operation
Commands
#set_web_port
Sets the HTTP listening port for the built-in web interface on the Matrix Controller.
The Matrix Controller must be rebooted after executing this command. The default port
setting is 80.
Syntax
#set_web_port port
Parameters
port
Type: INTEGER
The HTTP listening port. The port number can be from 0 to 65535.
Example
#set_web_port 80
WEB_PORT 80
Related Commands
#get_gateway
#get_ip_address
#get_ip_mode
#get_ipcong
#get_netmask
#get_web_port
#set_gateway
#set_ip_address
#set_ip_mode
#set_netmask
#set_port_mode