○○○○○○○○○○○○○○○○○○○○○○
Disk & Hard Disk 3•3
The file selector
The File Selector corresponds to the second level
of disk operations and is accessed by confirming
the command specified in the main page. Once
in the file selector, you can select the source
files and respective destinations.
The file selector is divided into two columns
showing (a) the source file directory (a contents
list) and (b) the destination directory. All «Disk»
operations, except the Erase command and the
Utility, copy or move files from a source to a des-
tination (e.g. from disk to RAM).
The direction of the copy or move operation is
shown in the status bar by an arrow pointing the
direction and the names of the
source
and
des-
tination
files.
The source device can be a floppy disk, the Hard
Disk or RAM. The device is selected with the
Soft buttons F1, F2 and F3.
Empty locations are represented by a broken line.
If you select a destination already occupied by a
file, the existing file is replaced by the incoming
one.
source
device
destination
device
page selection
(
)
device
selection
directory
refresh
file typequantity
available
memory
Main «Load» page
Limitations
Some file types cannot be handled more than
one at a time. MIDI Files, for example, can only
be handled using the SINGLE MIDI FILE com-
mand. Some files can be handled as Single ele-
ments, Groups and All sets, while others are lim-
ited to Single and All sets only.
The table below shows the valid commands for
each file type:
File Type Command
Block Single
Setup Single
Sound Single, Group, All
Real Perfs Single, Group, All
Style Perfs Single, Group, All
User Styles Single, Group, All
Song Single, Group, All
MIDIFile Single
«Load Single Song» File selector
Source
Directory
Destination
Directory
(a) (b)
To Next Page
Loading...
Need help?
General
