CE LITE-UM-251-9370
2 PARTS NAMES and FUNCTIONS
2-1
2 PARTS NAMES and FUNCTIONS
Operation panel
Media set lever - right
Cutter groove
Push roller
Tool carriage
Media set lever - left
Media sensor
Roll media stocker
Power switch Power supply connector
USB memory-dedicated port USB interface
Push roller positioning guide
Front Guide
Tool holder
Push roller Media holding roller (movable)
Operation panel .................................. Used to operate the device and congure various settings.
Media set lever - right ......................... Used to x (3 positions)/release the media by raising/lowering the
push roller. Adjust this lever position according to the width of the
media.
Media set lever-left .............................Used to x/release the media by raising/lowering the push roller.
Push rollers ........................................Press the media to x/move the media. Adjust the rollers position
according to the type and size of the media.
Push roller positioning guide
...................Indicates the position of the push rollers.
Tool carriage ....................................... Drives the tool left/right and scans registration marks or bar code.
Tool holder .......................................... Holds the tool and drives it up/down.
Media holding roller (movable) ...........Holds down media to prevent low cutting quality and malfunction of
registration mark detection. Set them in the center or the most lifted
part of the media.
Media sensor ...................................... Scans media.
Front guide .........................................Sets the media at the position of the indicated marking.
Roll media stocker .............................. Holds roll media.
Power switch ......................................Used to turn the power ON/OFF.
USB memory-dedicated port: .............Used to connect a USB memory for loading data.
USB interface .....................................Used to connect the device to a computer.
Power supply connector .....................Used to connect the power cable.
Cutter groove ......................................Used when trimming off a roll paper with a cross cutter.
To Next Page
Loading...
