GRAPHTEC CE LITE-50 - Cam Board L

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-25
6.2.11 Cam Board L
How to detach the cam board L
(1) Detach the left side cover (See subsection 6.1.2.).
(2) Remove the M3L6 self-tapping screw holding the cam board L, and then detach the cam board L.
M3L6 self-tapping screw
(3) Disconnect the cable from the cam board L.
How to reinstall the cam board L
(1) Reattach the cam board L in the reverse order in which it was detached.
Route the cable through the hook and the cable clamper as shown in the picture below.
Cable clamper
Hook