GRAPHTEC CE LITE-50 - ARMS Error Messages

CE LITE-UM-251-9370
9 TROUBLESHOOTING
9-6
9.6 ARMS Error Messages
Error
Code
LCD Display Cause Solution
E04001
Tilt with AXIS ALIGNMENT is too
large.
Reload the media.
E04002
Distance adjustment value
exceeds the setting range.
Reset to smaller value.
E04003 Failed to adjust the sensor level. This media cannot be used.
E04004
Distance adjustment value
exceeds the setting range.
Reset to smaller value.
E04005
Could not scan the registration
marks.
Check the registration scan
position.
E04006
Amount of data has exceeded
the I/O buffer size for the
segment area registration mark.
Decrease the data size.
E04007
Test pattern plotting position is
not within the plotting area for
sensor position adjustment.
Move the media toward center
and plot the test pattern.
E04008
Detected the media end while
detecting the registration mark.
Check the media.
Make sure the print position of
the registration mark.
E04009
Exceeded detection area while
detecting the registration mark.
Check the media.
Make sure the print position of
the registration mark.
E04010
Exceeded detection area while
detecting the registration mark.
Check the media.
Make sure the print position of
the registration mark.
E04011
Exceeded detection area while
detecting the registration mark.
Check the media.
Make sure the print position of
the registration mark.