GRAPHTEC CE LITE-50 - Width Sensor Adjustment

8 SERVICE MODE
CE LITE-UM-251-9370 8-6
8.4 Width Sensor Adjustment
Adjust the width sensor when the device can not detect the width or the tip of the media correctly.
Operation
(1) Turn on the CE LITE-50.
(2) Holding down the power button while the power is on.
(3) Select "ADJUST WIDTH SENSOR" on the TEST screen.
(4) Remove the media if it is set.
(5) Press "Execute" button to start adjusting.
(6) Press "Exit" button to return to the HOME screen after the adjustment is completed.