GRAPHTEC CE LITE-50 - Cutting Mat Base

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-56
6.2.25 Cutting Mat Base
How to detach the cutting mat base
(1) Detach the right side cover (See subsection 6.1.1.).
(2) Detach the left side cover (See subsection 6.1.2.).
(3) Detach the cross cut base (See subsection 6.1.4.).
(4) Detach the bottom cover (See subsection 6.1.5.).
(5) Detach the rear guide (See subsection 6.1.7.).
(6) Loosen the two M3L6 binding head screws holding the main board bracket.
(7) Remove the four M3L6 self-tapping screws holding the cutting mat base to the frame.
M3L6 self-tapping screws
(8) Disconnect the cables from the LED board L and LED board R.
LED board