GRAPHTEC CE LITE-50 - Chapter 5: Detailed Settings

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-61
6.2.27 LED Board L
How to detach the LED board L
(1) Detach the left side cover (See subsection 6.1.2.).
(2) Detach the cam board L (See subsection 6.2.11.).
(3) Detach the encoder disk L (See subsection 6.2.13.).
(4) Detach the press cover L (See subsection 6.2.15.).
(5) Loosen the three M4L6 binding head screws holding the X motor bracket.
(6) Detach the X drive pulley (See subsection 6.2.18.).
(7) Disconnect the cable from the LED board L.
(8) Remove the M2L4 self-tapping screw holding the LED board L, and then detach the LED board L
horizontally.
How to reinstall the LED board L
(1) Insert the LED horizontally into the hole on the cutting mat base.
(2) Tighten the M2L4 self-tapping screw to x the LED board L.