GRAPHTEC CE LITE-50 - Y Drive Belt Tension Arm

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-45
6.2.21 Y Drive Belt Tension Arm
How to detach the Y drive belt tension arm
(1) Detach the right side cover (See subsection 6.1.1.).
(2) Detach the left side cover (See subsection 6.1.2.).
(3) Detach the top cover (See subsection 6.1.3.).
(4) Detach the Y-exible cable cover (See subsection 6.2.1.).
(5) Detach the Y-exible cable guard (See subsection 6.2.2.).
(6) Loosen the M3L6 TP head screw holding the Y drive belt tension arm.
(7) Tighten the M3L6 TP head screw while pushing the Y drive belt tension arm in the direction of the
arrow to loosen the Y drive belt as shown in the gure.
M3L6 TP head screw
(8) Remove the two M2L5 self-tapping screws holding the Y drive belt guard, and then detach the Y
drive belt guard from the back of the tool carriage.
M2L5 self-tapping screw
Y drive belt guard