GRAPHTEC CE LITE-50 - LED Board R

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-60
6.2.26 LED Board R
How to detach the LED board R
(1) Detach the right side cover (See subsection 6.1.1.).
(2) Detach the cam board R (See subsection 6.2.10.).
(3) Detach the encoder disk R (See subsection 6.2.12.).
(4) Detach the press cover R (See subsection 6.2.14.).
(5) Disconnect the cable from the LED board R.
(6) Remove the M2L4 self-tapping screw holding the LED board R, and then detach the LED board R
horizontally.
M2L4 self-tapping screw
How to reinstall the LED board R
(1) Insert the LED horizontally into the hole on the cutting mat base.
(2) Tighten the M2L4 self-tapping screw to x the LED board R.
(3) Reattach the other parts in the reverse order in which they were detached.