CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-59
How to reinstall the cutting mat base
(1) Reattach the light bar holder to the cutting mat base.
(2) Place the light bar aligning its center to the light bar holder, and then push it until it clicks.
(3) Reassemble the other parts of the cutting mat base.
(4) Insert the cutting mat base from the right side, and then temporarily tighten both sides of the M3L6
binding head screws.
M3L6 binding head screw
M3L6 binding head screw
(5) Tighten the four M3L6 self-tapping screws on the bottom while pressing the center of the cutting
mat base to eliminate a gap.
(6) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
