GRAPHTEC CE LITE-50 - Aborting and Pausing a Cut

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-58
(2) Remove the two M2L4 self-tapping screws holding the LED boards, and then detach the LED
boards from both sides of the cutting mat base.
M2L4 self-tapping screws
(3) Remove the four M2L3 binding head screws holding the light bar holders on both sides of the
cutting mat base, and then detach the light bar holders.
M2L3 binding head screws
(4) Detach the light bar from the cutting mat base.
(5) Remove the M2L5 self-tapping screw holding the light bar holder, and then detach the light bar.
Light bar holder M2L5 self-tapping screw
Front Rear