GRAPHTEC CE LITE-50 - Pinch Roller Bush L

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-76
6.2.32 Pinch Roller Bush L
How to detach the pinch roller bush L
(1) Detach the left side cover (See subsection 6.1.2.).
(2) Detach the cam board L (See subsection 6.2.11.).
(3) Detach the encoder disk L (See subsection 6.2.13.).
(4) Detach the press cover L (See subsection 6.2.15.).
(5) Loosen the three M4L6 binding head screws holding the X motor bracket.
(6) Detach the X drive pulley (See subsection 6.2.18.).
(7) Detach the press unit L (See subsection 6.2.17.).
(8) Raise the cam lever.
(9) Detach the E-ring holding the pinch roller bush L, and then detach the pinch roller bush L.
How to reinstall the pinch roller bush L
(1) Reattach the pinch roller bush L in the reverse order in which it was detached.