GRAPHTEC CE LITE-50 - Motor

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-41
6.2.19 X Motor
How to detach the X motor
(1) Detach the right side cover (See subsection 6.1.1.).
(2) Detach the left side cover (See subsection 6.1.2.).
(3) Detach the bottom cover (See subsection 6.1.5.).
(4) Detach the front guide (See subsection 6.1.6.).
(5) Detach the cam board L (See subsection 6.2.11.).
(6) Detach the encoder disk L (See subsection 6.2.13.).
(7) Detach the press cover L (See subsection 6.2.15.).
(8) Detach the X drive pulley (See subsection 6.2.18.).
(9) Remove the three M4L6 binding head screws holding the X motor bracket, and then detach the X
motor bracket.
M4L6 binding head screws
(10) Disconnect the cable from the X motor.
(11) Remove the two M3L6 binding head screws holding the X motor, and then detach the X motor.
M3L6 binding head screws