GRAPHTEC CE LITE-50 - What is Printing & Cutting?

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-20
6.2.7 Width Detection Board
How to detach the width detection board
(1) Detach the right side cover (See subsection 6.1.1.).
(2) Detach the left side cover (See subsection 6.1.2.).
(3) Detach the top cover (See subsection 6.1.3.).
(4) Detach the carriage cover (See subsection 6.2.5.).
(5) Detach the pen board (See subsection 6.2.6.).
(6) Disconnect the cable from the width detection board.
(7) Remove the M3L6 self-tapping screw holding the width detection board, and then detach the width
detection board.
M3L6 self-tapping screw
Width detection board
How to reinstall the width detection board
(1) Reattach the width detection board in the reverse order in which it was detached.
CAUTION
Be careful not to tilt the width detection board forward when installing.