GRAPHTEC CE LITE-50 - Page 103

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-85
How to reattach the carriage assy
CAUTION
Be sure to work on a at surface such as a level block when reattaching the side frame.
(1) Reattach the carriage assy to the slide shaft.
(2) Insert the upper slide shaft to the carriage so that the D cut surface is on the left side, and then x
it with the M3L6 TP head screw to the right side frame.
(3) Align the two bosses with the holes in the left side frame, and x the left side frame with four M4L6
binding head screws.
Be sure to t the slide shafts to the left side frame rmly.
Make the D-cut surface
positioned forward
(4) Tighten the M3L6 TP head screws to x the slide shafts to the left side frame.
(5) Apply an appropriate amount of SANKOL CFD-5010-Z to the entire slide shafts.
(6) Reattach the other parts in the reverse order in which they were detached.