CE LITE-UM-251-9370
iv
7 ADJUSTMENT ...........................................................7-1
7.1 Setting Values of the Main Board..................................7-1
7.2 Selecting Language & Unit of Length ...........................7-4
7.3 Upgrading the System Firmware ..................................7-5
8 SERVICE MODE .........................................................8-1
8.1 Self Diagnostic Test ........................................................8-1
8.2 Clear Setup Mode ...........................................................8-3
8.3 Self Test ...........................................................................8-5
8.4 Width Sensor Adjustment .............................................8-6
9 TROUBLESHOOTING .................................................9-1
9.1 The Plotter Doesn't Operate Even When Turned On ...9-1
9.2 Media Loading Operations ............................................9-2
9.3 Cutting Operations .........................................................9-3
9.4 Error Messages in GP-GL Command Mode ...................9-4
9.5 Error Messages in HP-GL Command Mode ...................9-5
9.6 ARMS Error Messages .....................................................9-6
9.7 Other Error Messages .....................................................9-9
10 Parts List .................................................................10-1
10.1 Outer Casing .................................................................10-1
10.2 Main Frame ...................................................................10-2
10.3 Main Board ....................................................................10-4
10.4 Motor .............................................................................10-5
10.5 Press Unit ......................................................................10-6
10.6 Tool Carriage.................................................................10-7
10.7 Roll Stocker ...................................................................10-8
To Next Page
Loading...
