CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-33
How to reinstall the press unit R
(1) Firmly t the drive roller shaft to the bearing of the press unit R, and then reattach the press unit R
to the frame aligning to the notch.
(2) Spread a suitable amount of SUMITEC 305 to the camshaft and the top of the press unit as shown
below.
(3) Reattach the camshaft to the frame with its D-cut surface facing up, and then reattach the cam
lever to the camshaft.
D-cut surface up
Cam lever lowered
Camshaft R.
(4) Tighten the three M3L6 binding head screws to hold the press cover R.
(5) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
