GRAPHTEC CE LITE-50 - Cutting Roll Media

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-36
How to reassemble the press unit L
(1) Apply SUMITEC 305 to the press hold sliding area on the press box.
Apply SUMITEC 305 to the both
sides of the press box.
Press box
Press hold sliding area
(2) Reassemble the press unit L in the reverse order in which it was disassembled.
How to reinstall the press unit L
(1) Firmly t the drive roller shaft to the bearing of the press unit R, and then reattach the press unit R
to the frame aligning to the notch.
(2) Spread a suitable amount of SUMITEC 305 to the camshaft and the top of the press unit as shown
below.