GRAPHTEC CE LITE-50 - Page 57

CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-39
How to reinstall the X drive belt
(1) Apply a suitable amount of grease to the three places on the inside of the X drive belt.
(2) Reattach the X drive belt to the X drive pulley and the X motor pulley.
X motor pulley
(3) Spread a suitable quantity of TB1401B on the M3L6 binding head screw holding the X drive pulley,
and then tighten the screw to x the X drive pulley.
(4) Insert the spacer (0.5 mm) between the X motor bracket and the frame to secure the space.