6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-48
How to reinstall the Y drive belt tension arm
(1) Reassemble the Y drive belt tension arm.
(2) Attach the Y drive belt tension arm to the bracket, and then pass the Y drive belt through the Y
drive belt tension arm.
(3) Attach the spring to the Y drive belt tension arm and the frame.
(4) Temporarily tighten the M3L6 TP head screw while pushing the Y drive belt tension arm in the
direction of the arrow as shown in the picture below.
M3L6 TP head screw
(5) Insert the both ends of the Y drive belt to the notch of the tool carriage.
(6) Attach the Y drive belt guard to the tool carriage.
(7) Attach the Y-exible cable guard to the frame.
(8) Remove the M3L6 TP head screw holding the Y drive belt tension arm to adjust the Y belt tension
automatically.
(9) Re-tighten the M3L6 TP head screw after spreading a suitable quantity of TB1401B on the screw.
(10) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
